
Medium Voltage electrical Cabinets
Metal enclosed MV cabinets are compact modular structures made with top quality metal sheets with a thickness of not less than 2 mm painted with a RAL 7035 colour with a textured surface.
The fundamental prerogatives of this type of cabinet are:
- Operator safety
- Modularity of the system that allows the realization of any system solution
- Easy operation thanks too HMI, synoptic graphic display
- Use of circuit breakers, insulated in vacuum or in SF6, which allow easy operation, do not require maintenance of the power parts and reduce the maintenance of the control parts
The supply of the cabinets is always accompanied, both in paper and digital format, by the following documentation:
- Final drawing
- Test report
- Declaration of conformity with the CEI EN standards in force
- Technical documentation relating to the equipment used
In addition, reports relating to peak withstand tests, short-time currents on the protection circuit and dielectric tests will be available.
Technical data sheets
Test Reports
Dielectric Tests
Temperature Rise Tests
Mechanical Operation Tests
Cabin Protection Degree
Medium Voltage electrical Cabinets Test Reports
Medium Voltage electrical Panels Features
SAIE, in addition to the standard execution with constructive and electrical characteristics listed below, can provide special creations on request, in carpentry suitably designed and adapted to the uses and positions most suited to the Customer, entirely designed, manufactured, painted and assembled in its own headquarters of Piacenza.
Medium Voltage electrical Cabinets Features
Construction
features
- Bearing structure, panels and doors in 20/10 mm sendzimir sheet steel
- Hinged front doors with handle
- Side, rear and front upper panels fixed with screws accessible from the outside
- Internal metal segregations
- Panoramic porthole on the front of the cells
- Degree of protection IPH 3 with doors closed and IPH 2 with doors open
- Final color RAL 7035 orange peel
- Current earth bars in the lower front part of the switchboard
- Synoptic in relief in colored plastic laminate, all over the picture
- Key locks on the maneuvers
- Arrangement for internal lighting with command and lamp change from the outside without cutting off voltage
- Rounded-edged electrolytic copper busbars, air-insulated and revived
- Load-bearing insulators
- Hollow amar irons
- Lifting eyes
- Standards monitoring signs
- Sectionable terminals for TV
- Short-circuitable terminals for CT
- LSC2A service continuity category
Electrical characteristics
- Rated voltage: 24kV
- Rated frequency: 50Hz
- Nominal bus bar current: 630A
- Short duration current for 1 sec .: 12.5 / 16kA
- Test voltage for 1 min. at 50Hz: 50kV
- Pulse voltage: 125kV